Gravesend BM by Discount Builders Merchants, Northfleet

A raised bed in treated timber

A raised bed lifts the soil clear of a poor yard surface, and on the small gardens of Northfleet and Perry Street it is often the only place a row of vegetables will fit. This guide makes a 2.4 by 1.2 metre bed, 200 mm high, from treated boards, and counts the boards and the soil that fills it.

Gravesend BM is the Gravesend and Meopham delivery site of Discount Builders Merchants (KENT) LTD, the builders' merchant at Lower Road, Northfleet, DA11 9BB. There is one yard, and orders are placed on www.discountbm.co.uk.

Stacks of treated timber with stickers in the yard

Choosing the timber

The boards are 4 by 2 in the old naming, which is 100 mm wide and 47 mm thick. Two courses of them make a bed 200 mm high, deep enough for most vegetables and low enough to reach across without kneeling. Choose timber treated for ground contact, because the boards will sit against damp soil for years, and untreated boards rot at the bottom first.

Sawn treated timber comes in fixed lengths, and the boards for a bed are cut from three metre lengths. Plan the cuts before ordering. A 2.4 metre side cut from a 3 metre length leaves 600 mm, and two 1.2 metre ends from another length leave the same, which is enough for pegs and a brace.

Cutting and laying out

Each course has two long sides of 2.4 metres and two short ends of 1.2 metres. Cut the long sides first, then the ends, and check each pair against the other for square, because a bed out of square shows in the way the soil settles. Mark the cuts in pencil along the edge of the board, not on the face.

Lay out the outline on the ground with string or a hosepipe. Strip the turf and any weeds, level the ground and check it in both directions before the first course goes down. A bed on a slope needs its low side dug deeper, or the soil will run out at the bottom.

Fixing the corners

Corners are where a raised bed fails, so fix each board to the one beneath it with galvanised screws, and fix the corners with a batten or a short post on the inside. Stagger the joints between the two courses so that no two joins line up in the same corner.

On a wide bed, drive a stake or a post into the ground at each corner for extra stiffness. A membrane between the boards and the earth adds years to the timber, and it stops the soil washing out through the joints in the first winter.

Filling the bed

The bed holds about 0.58 cubic metres, which is 2.4 metres by 1.2 metres by 200 mm. Loose topsoil weighs roughly 1.3 tonnes a cubic metre, so a bed this size takes about 0.75 tonnes. A bulk bag of topsoil is a little more than that, and the shop does not publish its weight, so the yard confirms the count.

Fill in layers and firm each one lightly with the back of a spade. Topsoil settles after the first few weeks, so leave the bed a little proud at the top and top it up in spring. Topsoil that is dry is easier to move than topsoil that has been out in the rain.

Delivery or collection

The boards are 3 metres long, so they need a van with a long load bay or a roof rack. A car will not take them. Collection from the yard on Lower Road works for the boards, and the bulk bag is a delivery job, because it is too heavy to lift and too much for a side passage.

Say on the order where the bag can be set down, and the route from there to the bed. A bag left on a path is a bag in the way of everything else in the garden, so the drop point is worth a thought before the day.

Rules of thumb

Working figures for planning an order. Check them against your drawings and the product you choose.
Boards Two courses of 100 mm boards, 14.4 metres in all for a 2.4 by 1.2 metre bed.
Cutting Four sides of 2.4 m and four ends of 1.2 m, cut from six lengths of 3 m.
Fill The bed is 2.4 m by 1.2 m by 200 mm, which is 0.58 cubic metres.
Topsoil weight About 1.3 tonnes a cubic metre, so roughly 0.75 tonnes for the bed.
Bulk bag One bag, allowing about 0.8 tonnes; the yard confirms the count.

The shop has calculators that turn a measurement into a quantity.

Worked order: A 2.4 x 1.2 metre raised bed in Northfleet

Priced with the shop's prices today, last checked , and the yard's delivery charge to DA11. Amounts are ex VAT unless marked.
Product Quantity What it is for Cost
100x47x3000mm Sawn Treated Timber (4"x2") 6 at £5.99 Eight pieces across two courses, four of 2.4 metres for the long sides and four of 1.2 metres for the ends, cut from six 3 metre lengths. Each length leaves an off-cut for pegs. £35.94
Bulk Grade A Topsoil (BS3882) 1 at £69.00 The bed takes about 0.58 cubic metres, roughly 0.75 tonnes of topsoil. One bulk bag at about 0.8 tonnes, with the yard to confirm. £69.00
Goods £104.94
Delivery to DA11 £0.00
Delivered total ex VAT £104.94
Delivered total inc VAT £125.93

Bulk bags: the bags in this order are counted at about 0.8 tonnes each. That is a planning figure. The shop does not publish a weight for a bulk bag, so confirm the number of bags with the yard before ordering.

Not in this order: Corner posts, galvanised screws, the membrane under the bed, and the stakes that hold a wide bed square.

The quantities are a starting point for a job of this size. Put the same goods in a basket on www.discountbm.co.uk with your own postcode to see the figure for your order, or send the yard your list.

On the shop today

The products this guide talks about, from the shop's Timber & Sheet Material aisle. Prices last checked .

Prices are the shop's prices today. Stock and ordering are on www.discountbm.co.uk.

Sawn timber and sheet for Chalk and Shorne See all Timber & Sheet Material on the shop

Delivery to Gravesend and Meopham

DA11, DA12, DA13

Free when the goods reach £41.66 ex VAT (£49.99 inc VAT).

A smaller order pays the difference up to that amount: goods of £25.00 ex VAT (£30.00 inc VAT) pay £16.66 ex VAT (£19.99 inc VAT) for delivery.

Delivery charges by district · Contact the yard

More guides for Gravesend and Meopham